The D.R. Templeman Company

Specification Forms - Extension Springs • Compression Springs

Note: Specify only those parameters appropriate for your specific design. Specify refrence values for parameters that can be adjusted to meet the mandatory requirements. This form can also be printed, filled out, and faxed to 860-747-8297. All dimensions are assumed to be in inches unless otherwise specified.
		Mandatory Specifications	Reference Specifications
A	Free Length
B	Outside Diameter
	To work in a minimum hole diameter of:
C	Inside Diameter
	To work over a maximum shaft diameter of:
D	Pitch
E	Space between the coils
	Material
	Wire Size
	Finish
	Direction of Helix (R, L, or optional)
	Number of active coils
	Total number of coils
	Maximum solid height
	Type of ends (see Design Formulas and End Types page)
	Load 1 (Load at compressed height)	at	at
	Load 2 (Load at compressed height)	at	at
	Spring Rate
	Other (specify)

*Name:

Company:

Address:

City:

State /
Providence:

Zip:

Country:

*Phone:

Fax:

*E-mail:

Part Number:

Comments and Instructions:

Manufacturers of small springs and wire forms for the medical, fiber optic, electromechanical, automotive, electronics, hardware, pneumatic controls, crafts and hobbies, telecommunications, industrial instruments, consumer goods, jewlery, and sporting equipment industries.

The D.R. Templeman Company
1-800-203-4290
1 Northwest Dr., Plainville, CT 06062 USA
860-747-2709 • Fax: 860-747-8297