The D.R. Templeman Company

Specification Forms - Extension Springs • Compression Springs

Note: Specify only those parameters appropriate for your specific design. Specify refrence values for parameters that can be adjusted to meet the mandatory requirements. This form can also be printed, filled out, and faxed to 860-747-8297. All dimensions are assumed to be in inches unless otherwise specified.
		Mandatory Specifications	Reference Specifications
A	Length inside ends
B	Overall length
C	Body length
D	Opening or gap
E	Inside Diameter
F	Outside Diameter
	Material
	Wire Size
	Finish
	Types of ends (see Design Formulas and End Types page)
	Direction of Helix (R, L, or optional)
	Number of coils in body
	Relative position of ends (in line, opposite, or right angles)
	Load 1 (Load at ext. lg. inside ends)	at	at
	Load 2 (Load at ext. lg. inside ends)	at	at
	Spring Rate
	Initial Tension
	Other (specify)

*Name:

Company:

Address:

City:

State:

Zip:

*Phone:

Fax:

*E-mail:

Part Number:

Comments and Instructions:

Manufacturers of small springs and wire forms for the medical, fiber optic, electromechanical, automotive, electronics, hardware, pneumatic controls, crafts and hobbies, telecommunications, industrial instruments, consumer goods, jewlery, and sporting equipment industries.

The D.R. Templeman Company
1-800-203-4290
1 Northwest Dr., Plainville, CT 06062 USA
860-747-2709 • Fax: 860-747-8297